Where to Buy Eaton

Assemblies of electrical protective devices, buses, and control equipment used to distribute and protect power circuits at service entrances and distribution points. Switchgear and switchboards are used in commercial buildings to control and isolate electrical loads and provide overcurrent protection.

Electrical distribution equipment containing overcurrent protective devices that divide incoming power into branch circuits within an enclosure. Used in commercial buildings for lighting, power, and distribution loads, including load centers for smaller applications.

Overcurrent protective devices that automatically interrupt electrical circuits during overload or fault conditions. Installed in panelboards, switchboards, and distribution equipment to protect wiring and connected loads in commercial buildings.

Electrical devices that step voltage up or down between distribution and utilization levels within a building's power system. Dry-type and distribution transformers are used in commercial construction to supply appropriate voltages to panelboards and equipment, insulated with air or cast resin rather than liquid.

Electrical devices installed at outlets and control points, including receptacles, switches, dimmers, and occupancy sensors. Used throughout commercial buildings for power connection and lighting control at the point of use.

Cable tray is a rigid support system of metal ladders, troughs, or wire baskets used to route and support electrical and communication cabling. It is installed in commercial and industrial buildings to organize cable runs above ceilings, in plenums, and in equipment rooms.

Strut channel is a formed metal support framing used with fittings and hardware to mount and brace piping, conduit, cable tray, and mechanical equipment. It is used in commercial construction to build adjustable, field-assembled support systems.

The balance-of-system components of a photovoltaic installation excluding the modules themselves, including racking, wiring, combiners, disconnects, and mounting hardware. Used in commercial solar projects to mount, interconnect, and protect the array between the panels and the inverter.

Luminaires using light-emitting diode sources to provide illumination in interior and exterior applications. Used in commercial construction for general, task, and accent lighting, available in troffer, downlight, high-bay, and area fixture formats with a range of outputs and color temperatures.

Combiner boxes consolidate multiple photovoltaic source circuits into a single output with overcurrent protection, while power optimizers are module-level electronics that condition DC output to improve array performance under shading and mismatch. Both are balance-of-system components in commercial solar installations.

Metal and nonmetallic housings that protect electrical controls, terminations, and equipment from environmental and physical hazards, rated to NEMA and IP standards. Used in commercial and industrial installations to enclose panels, controls, and junctions.

Flexible and liquidtight conduit is a bendable raceway used to route and protect electrical conductors where movement, vibration, or moisture is present, such as motor and equipment connections. It is used in commercial construction for final connections to machinery and in wet or corrosive environments.