Where to Buy CertainTeed

Preformed blanket insulation made of spun glass fibers, sized to fit between wall studs, floor joists, and ceiling framing. Used for thermal and acoustic insulation in commercial wall and ceiling assemblies, available faced or unfaced.

Two-component polyurethane foam applied on site that expands and cures in place to provide insulation and air sealing, available in open-cell and closed-cell formulations. Used in commercial walls, roofs, and cavities for thermal resistance and air barrier continuity.

Acoustic insulation is a fibrous or foam material installed in wall cavities, floor/ceiling assemblies, and around ductwork to reduce airborne and structure-borne sound transmission. It is used in commercial construction to improve STC ratings in partitions between offices, hotel rooms, multifamily units, and mechanical spaces.

Regular gypsum board is a panel of noncombustible gypsum core faced with paper, used for interior wall and ceiling surfaces. It is installed on wood or metal framing in commercial construction where fire-rated or moisture-resistant boards are not required.

Fire-resistant gypsum panel with a glass-fiber-reinforced core that provides increased fire resistance compared with standard board, typically 5/8 inch thick. Used in rated wall and ceiling assemblies to achieve required fire-resistance ratings in commercial construction.

Gypsum wallboard treated to resist moisture and mold growth, commonly identified by green or purple facing. Used in bathrooms, kitchens, and other high-humidity interior areas as a substrate for finishes.

Shaftliner panels are moisture- and fire-resistant gypsum boards with a specialized core, typically 1 inch thick, installed vertically between shaft framing. They are used in commercial construction to form fire-rated enclosures for elevator shafts, stairwells, and mechanical chases in area-separation and shaft wall systems.

Gypsum panels faced with glass-fiber mats in place of paper for moisture and mold resistance. Used as sheathing, tile backer, and interior board in areas exposed to humidity or weather during construction.

Joint compound and tape are used to finish gypsum board seams, embedding paper or mesh tape in compound to conceal joints and fastener heads before painting. They are used in commercial construction to produce continuous, finished drywall surfaces at specified levels of finish.

Rigid panel of cement and reinforcing fibers used as a substrate for tile, thin brick, and exterior finishes. Provides a stable, water-durable backer in wet areas such as showers, kitchens, and exterior cladding assemblies.

Lay-in or tegular panels made of mineral fiber, fiberglass, or metal that drop into a suspended grid to control sound and conceal overhead systems. Used in commercial offices, schools, healthcare, and retail for acoustic absorption and access to plenum utilities.

Mineral wool or fiberglass batt insulation installed within interior partition wall cavities to reduce sound transmission and provide thermal resistance. Commonly specified in commercial interiors to meet STC acoustic ratings between office, tenant, and demising walls.

Metal, vinyl, and paper-faced corner beads, edge trims, and control joints applied at gypsum board edges and corners. Used to protect and finish drywall terminations and outside corners in commercial interior partitions and ceilings.

A low-slope roofing system constructed from alternating layers of bitumen and reinforcing ply felts, typically finished with a gravel or mineral surfacing. Used on commercial and industrial buildings to provide a durable, multi-ply waterproof membrane.

Sheet material installed over the roof deck beneath the primary roof covering to provide a secondary water-resistant barrier. Used in commercial roofing as felt, synthetic, or self-adhered membrane products beneath shingles, tile, or metal panels.

Cementitious or gypsum-based material applied wet in coats over lath or masonry to form a hard, continuous interior or exterior finish. Used in commercial construction for veneer plaster, three-coat systems, and ornamental finishes.

Metal framework of main runners and cross tees hung from the structure to support acoustic ceiling panels and lay-in fixtures. Used in commercial interiors to form a level suspended ceiling plane with access to the plenum above.